Plasma cutter repairs
Single phase or 3-phase, portable or workshop, we diagnose and repair plasma cutters and their torches. And because we stock plasma consumables for all the common torch types, a worn part doesn't mean waiting on a courier.
Back to clean cuts
No pilot arc
Machine powers up but the torch won't fire or won't transfer to the work.
Poor cut quality
Bevelled, dirty or incomplete cuts from worn consumables or air problems.
Air supply faults
Pressure, moisture and filter problems that shorten consumable life.
Torch damage
Damaged torch heads, leads and switches repaired or replaced.
Power faults
Inverter, board and power faults on single and 3-phase machines.
Consumables
Tips, electrodes, swirl rings and shields for the common torch types.
Is it the machine or the consumables?

Many plasma problems start with worn consumables or a poor air supply rather than the machine itself. Before you book a repair, check:
- Electrode and tip. A pitted electrode or an oval tip orifice ruins cut quality. Replace them as a pair.
- Air pressure. Set it to the machine's recommended pressure while air is flowing.
- Moisture. Wet air destroys consumables fast. Drain the compressor and filters.
Still no luck? Then it's a job for the workshop. We stock parts for Thermal Dynamics, Trafimet, Tecmo/Cebora and ESAB PT31 style torches, among others.
Back to work in four steps
Book
Call, email or book online in under a minute. We'll call you back within 2 hours.
Pickup
Free pickup across Christchurch metro, or drop off at 243 Annex Road. Freight arranged from anywhere.
Diagnose & repair
Diagnosed and fixed by our technicians, with common parts in stock. All major brands.
Back to work
Load tested to factory spec and returned. Over 90% within 4 working days.
Plasma repair questions
Straight answers from our workshop team.
Talk to a technician, Mon–Fri 8am–5pm.
Why won't my plasma cutter fire?
Common causes are worn or incorrectly fitted consumables, low air pressure, a faulty torch switch or a fault in the machine's pilot arc circuit. Check the consumables and air first; if those are fine, book it in.
Do you stock plasma consumables?
Yes. We carry tips, electrodes, swirl rings and shields for the common torch types, including Thermal Dynamics, Trafimet, Tecmo/Cebora and ESAB PT31 styles.
How long do welder repairs take?
Over 90% of our repairs are back with their owners within 4 working days, as long as the parts are readily available. We stock a wide range of common parts to keep turnaround fast.
Do I get a loan machine while mine is repaired?
Yes, we provide a free loan machine for most standard repairs on commercial machines, so your production doesn't stall. Loan machines aren't available for hobby machines. Please mention it when you book.
Plasma torch parts & consumables
Book your plasma cutter repair
Repair requests go straight to our repairs team.
Welder down? Call now.
Talk to the workshop, book a pickup or arrange a loan machine.
